LIXiSE LXC9210 Completely replaced dse 7210 diesel engine genset control module

Description

LXC9210 plant automation controller series diesel generator sets for a single automation and control systems, the use of 32-bit microprocessors and embedded real-time systems technology, turbine automatic start / stop, a variety of parameters precision measurement, alarm protection and "three remote "function. The controller uses LCD screen (240 * 128LCD) graphic display can be displayed on one page under almost all the important parameters, save the page. Also can display Chinese, English and other languages, all parameters can be adjusted from the control panel, or use a PC via USB, RS232, RS485, LINK or GPRS remote adjustment and monitoring. Its compact, simple wiring, high reliability, and can be widely used in various types of generators automation systems, but also for fire pumps, air compressor automation control systems.

-With SMS function, when there is an alarm generator can automatically set 5 phone numbers to send alarm information can also be controlled via SMS turbine generator sets and inspection status.

-Acquisition and display mains / generator phase voltage, phase current, phase sequence, frequency, active power, reactive power, power factor, power, various engine sensor data;

-Mains overvoltage, undervoltage, over and under frequency, phase, reverse phase sequence warning function, power generation has overvoltage, undervoltage, over and under frequency, over current, over power, reverse power, phase, reverse phase sequence warning and shutdown protection;

-Three fixed analog sensors (temperature, oil pressure, liquid level), two programmable analog sensor can be set to the temperature or pressure or liquid level sensor

-A heater, cooler, fuel pump control functions;

-There fault history 200, can record instant warning or failure occurs in hydraulic, water temperature, voltage, current, power, and other important parameters, easy to analyze the causes and maintenance;

-There are real-time clock, timer switch (monthly / weekly / boot once a day and can be set with or without load) function;

-Group with three maintenance functions can be set to machine maintenance cycle. Maintenance time can be set to the action (warning or alarm shutdown);

 

Specification: 

 

Power Supply	8 to 35 Vdc Continuous
Cranking Dropouts:	Able to survive 0 V for 50 mS, providing supply was at least 10 V
	before dropout and supply recovers to 5V.
Max Current	Operating 425mA at 12 V & 215mA at 24 V; Standby 250 mA at 12 V & 125 mA at 24 V.
Start Relay Output:	16 Amp DC at supply voltage.
Fuel Relay Output:	16 Amp DC at supply voltage.
Auxiliary Relay Outputs:	5 Amp DC at supply voltage.
Charge Fail / Excitation Range	0 V to 35 V
Maximum operating current	320ma at 12V, 215ma at 24v
Maximum operating current	175ma at 12V, 95ma at 24v
Alternator Input Range:	15V(L-N) to 333V AC (L- N) absolute maximum
Alternator Input Frequency:	50 - 60 Hz at rated engine speed (Minimum: 15V AC Ph-N)
Magnetic Pick-up Voltage Input Range:	+/- 0.5 V to 70 V Peak
Magnetic Input Frequency:	10,000 Hz (max) at rated engine speed
MAINS (UTILITY) SENSING INPUT RANGE	(DSE5220 only)
	15V (L-N) to 333V AC (L-N) absolute maximum
MAINS(UTILITY)SENSINGINPUTFREQUENCY	(DSE5220 only)
	50-60 Hz
MAINS (UTILITY) & GENERATOR LOADING	(DSE5220 only)
RELAY OUTPUT	8A AC 250V
Generator loading Relay Output:	8 Amp AC 250V.
Mains loading Relay Output:	8 Amp AC 250V
Panel Cutout:	220mm x 160mm ( 8.7" x 6.3")